SET TEAR - Tear-off Mode

ConfigurationUnsupported

Plain English

Toggles the printer's tear-off behaviour (TSPL2 PG §SET p143–144; alias STRIPER on some models). When ON, the printer advances each label past the tear bar after printing so the operator can tear it off cleanly; when OFF, the label stops at the print head. Persistent across power cycles.

When to use

For tear-bar-equipped printers when the deployment requires the print head to advance the label for clean tearing.

Syntax

SET TEAR ON | SET TEAR OFF

Parameters

ParameterDescription
state
Tear-off mode (case-insensitive).
  • ON - Enable tear-off — advance past tear bar after each label
  • OFF - Disable tear-off — stop at the print head

Example

SET TEAR ON

Enable tear-off advance after each label

Try it in the playground View all TSPL commands